How to fasten a thin drill in the chuckThere is a great need to drill a small diameter hole, for example, in the circuit board for radio elements or wherever. To do this, usually use a screwdriver. And if you decide to clamp a thin drill in his cartridge, then it will work out. The one who faced this - I will understand. The fact is that the clamping jaws of any drill or screwdriver have an initial gap, which will not be reduced even by the strongest tightening. Plus, this gap increases if the tool is often used and if your tool is not one year old, and eventually the distance fizzled out can reach 1-3 mm. The classic way out of this situation is to use a special drill with a collet chuck . Which is intended for installation in it of drills of small diameter. And what to do if this is not near at hand? How to fix a miniature drill, so that it does not give a beat during drilling? Getting out of this situation turns out to be quitesimple.
- Copper wire 0.2-0.8 mm thick.
- The miniature drill you need to use.
A way to fix a thin drill in the screwdriver or drill chuckTake a wire and wind it tightly to the turn of the drill to the tail of the drill, which will be clamped .
The main purchases to be made before the end of summer
How not to rip the lower back during sports
Which jacket to choose in 2015
Standalone software for plotting diagrams
Argentina is an amazing country with an unusual culture (9 photos)
How to attract happiness